The remote pressure head also provides an extra margin of safety and convenience by removing the calibrator and operator from the pressure source in the event that semi-remote measurements are needed. With this modules, any medium that is compatible with stainless steel can be used on the high side of the module.Ī urethane overmolding protects against shock if the module is accidentally dropped it also seals against dirt, dust, and moisture.Ī one-meter cable between the pressure module and calibrator reduces the length of connecting tubing to the pressure source. The 750P07 incorporates a stainless steel diaphragm to isolate the sensor. Each module has its own serial number to maintain independent traceability. Lastly, the modules are fully interchangeable, because all measurements are completed in the pressure module itself and then communicated to the calibrator in digitized form.Īll modules, including the 750P07, are calibrated independently of the calibrator, and can be used with any 740, 750 or compatible 720 or 710 series calibrator. 1 pound per square inch 144 pounds per square foot. This tool converts pounds per square inch to pounds per square foot (psi to psf) and vice versa. Therefore, 1 atmosphere is approximately 14.696 pounds per square inch. Secondly, the modules are inherently temperature-compensated from 0° to 50☌ (32° to 122☏). It is the pressure resulting from a force of one pound-force applied to an area of one square inch. 00 pascal Pa bar to pascal, pascal to bar. Then, as pressure measurements are made, raw sensor values for pressure and temperature are digitally loaded to the calibrator, where the raw sensor values and coefficients are manipulated to derive and display the pressure reading.īecause of this innovative technique, digital communication eliminates errors due to poor connections and electrical interference. pascal Pa 1 kilopascal kPa 1000 pascal Pa kilopascal to pascal, pascal to kilopascal. When connected to the calibrator, the module's coefficients are uploaded from the pressure module to the calibrator. The 750P07 has its own microprocessor, allowing it to run the measurement circuitry and communicate digitally with a calibrator. Pressure Module Performance and Technology This saves time, eliminates errors, and supports compliance with quality standards and regulations. When used with the 750 Series Documenting Process Calibrators, pressure readings can be date/time stamped and stored electronically for later retrieval. At the touch of a button, the pressure may be displayed in up to 11 different engineering units. Apply pressure from the pressure source and it is displayed digitally on the calibrator. To measure pressure, connect the pressure module to a pressure source or hand pump and then connect the pressure module cable to the calibrator. The formula to convert from psi to bar is: bar psi ÷ 14. Convert Psi to Pound Force Per Square Foot (psi in lbf/ft2). The Fluke 750P07 Gauge Pressure Module, 0 to 500 psi, 0 to 35 bar, 0 to 3500 kPa (Stainless Steel) is easy to use. 28 Bar (bar) Visit 90 Bar to Psi Conversion. Inspection Tools, Lights, Magnifiers, and Microscopes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |